Originally Posted by Iwamotto Tetsuz
I think if your brought your stuff manually instead of using their kit, it should get you more parts.
250usd to rmb is about 1660 rmb.
A sc600 which is what you are using now, cost 50-70rmb.
fittings cost 1-2rmb per barb and 0.5-1rmb for a barb lock, and 3-5rmb for a compression fitting, tubes cost 1.2 rmb for a meter,
rads cost 400rmb for 480mm long 45mm thick pure copper radator, 230rmb for high quality pure copper radiator but is only 25mm thick, but has low resitance
alloy rads cost 130 approximatly for 360mm rads, 25mm thick and they used to sell 45mm thick alloy rads for 139rmb but then they stopped.
water blocks cost 68rmb for a good one, 5mm thick non jet. I have this block and with comparison to my other blocks that are jet and comparison to a cooler master micro channel block which has been lasped, its pretty much performing the same in terms of performance. most expensive chinese block for cpus cost about 130rmb-300rmb
res cost 39-60rmb for 300mm tall ones, with fiting for rad includined is about 49rmb average
GPU blocks cost a bit more, if you want the one thats a full cove its about 300-1000rmb, but 30-80 for a universial fit and about 130 for a gpu and ram coverage block.
you can get fans that are only 8rmb each, and has duall ball bearings, and you have allot to chose from just in the 8 rmb per 12cm fan range.
this seems to cheep to belive right? I have brought some my self and used them before, hard to belive its this cheap in china but it is
Of course, because the cheapest stuff is from diffrent selers on taobao you have to pay some extra 20rmb approximatly if its shipping to a house in china for every diffrent seller you order from