Overclock.net › Forums › Case Mods & Cases › Other Hardware Mods › Plastidip on Roccat Kone + and fans
New Posts  All Forums:Forum Nav:

Plastidip on Roccat Kone + and fans

post #1 of 2
Thread Starter 
The silver Roccat logo on my Kone + mouse has degraded quite a bit and I was thinking about spraying the left vertical face the plam/top side and the right veritcal face with a matte blue Plastidip to cover the degraded logo and make it look cool.


Q1. Will Plastidip stick well to the slightly rubberized surface?

Q2. Will Plastidip last? (i don't generally wash my hands before using my mouse so that's probably why it went bad in the first place)

Q3. Will Plastidip peel on its own when I don't want it to?



Then with the leftover Plastidip I am hoping to paint the blades (but not cage) of at least one maybe three of my fans in my Antec 900.


Q1. Anything wrong with painting fans?

Q2. Should there be enough left in one can after the mouse is painted? If so how many fans do you think I could paint?

Q3. How do you think a matte blue fan would look with blue LED's shinning into them?

Q4. Can you find a similar example? (I didn't see one)
post #2 of 2
I'm not sure about the fans but the mouse should be fine just make sure you remove the top cover and wash it thoroughly to ensure a good surface to grip onto. Don't forget plastidip takes around 48 hours to complete finish although you can normally use it within an hour!
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Other Hardware Mods
Overclock.net › Forums › Case Mods & Cases › Other Hardware Mods › Plastidip on Roccat Kone + and fans