Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Case Mod Work Logs › [build log] Cooler Master Storm Trooper "Crystal Abyss"
New Posts  All Forums:Forum Nav:

[build log] Cooler Master Storm Trooper "Crystal Abyss" - Page 2

post #11 of 15
Thread Starter 
Today is going to be a progressive day all viewers and subscribers stay tuned for a massive update and description modification!
post #12 of 15
Thread Starter 


Im attempting to quick dry the rads by uv
post #13 of 15
Thread Starter 


This one doe
post #14 of 15
Thread Starter 


Gotta pay some more attention to this little guy here.
Just sanding down corners and rounding them off.
post #15 of 15
Thread Starter 


This bottom area is where cooler master intended us to place a 240mm rad if we chose. I placed white zipties to show where they intend for the screws to be placed if you choose to install a 240mm rad. I'm going to be cutting this out and placing this on the lower front grill where the front panel is placed as I mentioned ill be lining the inside of the case with an opaque plexiglass look. The plexi wont hold up as well in comparison so this will be drilled and screwed into the front panel support beams and a small screw drilled through on the bottom, holding this honeycomb looking piece of steel to not only the beams but the floor of the case as well.

Stay tuned.
Edited by royce5950 - 1/7/14 at 3:01pm
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Case Mod Work Logs
Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Case Mod Work Logs › [build log] Cooler Master Storm Trooper "Crystal Abyss"