Overclock.net › Forums › Cooling › Water Cooling › First Watercooling Project
New Posts  All Forums:Forum Nav:

First Watercooling Project - Page 3

post #21 of 24
Thread Starter 

The idle temp im reading is from the bios
The VRM water block has barbs which are not compatible with rigid tubing

As far as using compression fittings, primochill makes rigid compression fittings, they are sustained using rubber o rings to prevent leaking.
Edited by Rhage - 3/3/14 at 3:46pm
post #22 of 24
Quote:
Originally Posted by Reckit View Post

Correct me if I'm wrong but your list of components mentioned compression fittings, it didn't think you could use them for ridged tube builds

From the picture above your post I can't really tell but it looks like they are compression??
post #23 of 24
Quote:
Originally Posted by Rhage View Post


The idle temp im reading is from the bios
The VRM water block has barbs which are not compatible with rigid tubing

As far as using compression fittings, primochill makes rigid compression fittings, they are sustained using rubber o rings to prevent leaking.

where are your rad fans?
post #24 of 24
Thread Starter 
on the other side of the rad, pulling air from outside, pushing it into the case, 3 fans, set at 4250 rpm. (more than enough air flow lol, can feel the air pushing out really strong even standing behind the case through the pci ports lol)

Also, I have 2 120mm fans to mount on the top of the case, above the tube, I just haven't got to it yet, but i don't see that making much of a difference
Edited by Rhage - 3/3/14 at 7:32pm
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Water Cooling
Overclock.net › Forums › Cooling › Water Cooling › First Watercooling Project