Finally got the acrylic to my satisfaction. Had to redo it a few times due to miscalculations and change of fittings.
Then I had a few leaks. Then i ran out of acrylic...Conclusion:
Your cuts need to be 100% straigt. And the edges needs to be sanded just a little, not too muc.
Temperature to high: Bubbles
Temperature to low: white lines from strains
Bend to much: wrinkles
More than 2 bends on a short peice: Skill level required: Master
Measurements +/- 0.5mm divergence MAX!Number of rage quits:
Now I´ve done 2 x 8 hour leak testing.
Because some of my pieces are longer than 400mm I need to design a small rack where both the longer pipes go trough,
to keep them from tilting due to length and weight.
So no gaming on my new rig just yet. Back to the drawing board!