Overclock.net › Forums › Graphics Cards › AMD/ATI › ATI Cooling › dimension about VRM length
New Posts  All Forums:Forum Nav:

dimension about VRM length

post #1 of 4
Thread Starter 
i will buy a referance Asus 290x. so i will build a wc loop with 290x. and i will use EK supremacy universal vga block bridge edition which will come next 5-10 days. i found a solution about cooling VRMs with heatsinks. but i need an info so what is the length(mm) between two holes that are superior and inferior of VRMs? i think i may make a custom heatsink.


Edited by drserk - 3/9/14 at 11:05pm
post #2 of 4
The PCB width is about 10 cm or 9.9 cm.
So what I did, is scale down this picture until the PCB measured 10 cm on my screen (Epic level of laziness) on a 1080p monitor.

This is the image that I have been using...measures to 8.5 cm
http://oi57.tinypic.com/2crlwt1.jpg
Edited by KGBinUSA - 3/12/14 at 9:24pm
post #3 of 4
Thread Starter 
thank you so much thumb.gif
post #4 of 4
The max width is somewhere in the 12-14mm range as well, from caps to (chokes?) The thing I bought (hr-09u) just barely fit.

Just figured I'd give another dimension tongue.gif
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: ATI Cooling
Overclock.net › Forums › Graphics Cards › AMD/ATI › ATI Cooling › dimension about VRM length