Thanks guys. Knowing there is at least some stalkers is good motivation. At this point, I am committed to finish it.
Here's how it currently sits20160116_151121
I had to remove the PSU bracket to slide it slightly out of the frame so I could remove the pump bracket to slide the pump out of the way of the GFX card. Obviously to do any work. I had to remove the rad and 660.
Because It is only a 430W PSU. I needed to power up the 800W I had lying around
A. I didn't have 2x 6pin
B. Per a PSU calculator, I'm right around 420W stock.
GPU block should be here Thurs per tracking. Since I've had time to ponder, I've been looking at doing hard tube like copper. The only problem is I would have to wait even longer to get the fittings since it doesn't seem to be an option at the hardware store from my reading in the pipe bending 101 thread. I think this would clean up some of the tubing I have now and give the build a nice accent.
I may try to get a push/pull again if I can get tubes cleaned up and there is enough between psu and rad. This is also provided I can fit the pump between the psu and the gpu.
As for being packed. I'm not sure it could be more than it is
Final build should be at least close to:
4" cylinder Res (may have to be removed)
280 Rad (2x140mm) w/ 2x140mm fans
600W SFX PSU
Also, I'm probably going to re add the tumor. It' wasn't the prettiest but did give me a few extra degrees while running the 660 and 4770k. The 980 is ~20W more power stock so it should have more of an effect now.Edited by outlaw8505 - 1/19/16 at 9:23am