Originally Posted by Mega Man
Ok, so by "4 fan over current " you mean channel 4 fan not all four fans ?
I think i misunderstood you, sorry. Lets start over
Is this a first time run ( since rebuild/build ? )
Did you just walk to your pc and notice the issue (and change nothing ) or did you plug and unplug something then this issue started?
Do your pump(s) receive power from the aquaero or do they receive power directly from psu via the fat 4 pin?
If you remove the connector from channel 4, does the alert stop?
This is a completely new build (almost the same as this one with 11 GPUs see /watch?v=Uk2qIYvgFaE)
4th channel is marked as red in aquasuite with an error about overcurrent - this is present since first installation of aquasuite. To this 4th channel only PWM blue and green cables are attached that transmit PWM control to D5 EK pumps (not power, cause power is provided by PSU molex cables).
So when I turn the aquaero on I see the error displayed and no signal on 4th channel - see the photos.
PS Huge thank you for your time and help. I hope Shoggy helps too.