Originally Posted by NE0XY
Not quite sure what you meant with the calibration thingy but thanks =)
Would be interesting to see my actual flow but that won't be possible?
If you look at the flow meter settings there is a place where you can adjust the number of rotations (pulses actually) per Litre. The standard 3 pin Aquacomp model is around 169 but the Bitspower model is under 100. The Aquaero settings can't be set to under 100 though. So you can't get really accurate but setting it to 100 would be closer than it must be now.
I assume the very large difference in the config numbers is due to the fact that the Aquacomp model produces two pulses per full rotation of its paddle whereas the BP sensor is just reporting RPM so is likely a single pulse per rotation
Originally Posted by jaganram
Sorry for this dumb question how do i connect Aquaero 6 to my board ? Yes i found the 5 pin USB cable which i got with my Aquaero. I need to connect it directly to a USB2.0 header in my R5E.
Seen the USB header on the board has completely different pin arrangement. So how do i connect this ?
The USB 2.0 headers are dual ports, so you can connect two of the 5 pin cables that come with the Aquaero to each usb header.Edited by Jakusonfire - 10/21/15 at 12:18am