I hive the “Aquaero 6 XT blue USB fan controller, graphic LCD, touch control, IR remote control" to control pump and fan. My fans working fine.
My problem is with the “”EK-XTOP Revo D5 PWM - Plexi (incl. pump “”
The EK-D5 ( PWM Response ) 1450 to 4800 PWM
Right now I’m using the CPU1 header on msi godlike MB to control the pump.
When I use CPU1 header to control the pump, it doesn’t keep any setting that apply. It return back to default, using MSI Command center even when save a profile setting. Also try the setting in the bios. But everytime I boot the system it reset back default. 40c @ 45% which the pump will running @ 1450 to 1850 RMP.. I did had it working before I update the bios. As the temp rise, the pump will speed up the flow.
So try use the Aquaero 6 xt to control the pump, but doesn’t work. I no that it’s not a Aquaero Pump
. But D5 PWM pump do work. And hive tested the pump in difference speed. So its working fine.”
On any fan header that are PWM control that I use, The max speed I get 2010 PWM, no matter what configuration I set to, it stay at 2000 PWM. I so have a powerjusted 3 ultra, but doesn’t hive PWM to control the pump. Only speed senor. The EK-XTOP Revo D5 PWM has fore wire's power 12v and one yellow and one blue.
The blue wire = speed control
The yellow wire = speed senor
Can anyone please shed some light on this matter?
How to setup this stupid pump... with software / hardware.
Its working fine with CPU1 or CPU2 header and MSI command center`
BUT I hive to go in there manually to just the temp/speed. Every time boot the system.
PS. I was toll that mod can fix this. (As for the D5 pump with the Aquaero, it is a well known issue. You need to modify the PWM connector, have a look in the Aquaero thread here on the forums. Search for Diva mod.)
looking for link on this information.
ThanksEdited by Vipercat - 1/27/16 at 3:32pm