Overclock.net › Forums › Cooling › Water Cooling › H90 AIO for GPU in 800D
New Posts  All Forums:Forum Nav:

H90 AIO for GPU in 800D

post #1 of 4
Thread Starter 
So far i've got an H100i in the top of my 800d, and wanted to use the new Kraken G10 on my 670 FTW. But as to keep the use of the rear fan, i want to try and mount an H90 on the bottom fan bracket above the power supply, but wasn't sure if anyone has done this before, or if i would get enough airflow for the H90 to work well enough mounted there. Any suggestions or info would be lovely.
post #2 of 4
You could mount the radiator behind the H100i radiator and it would be cooler than most aircoolers can muster.

I can safely say it will work well anywhere you can mount it unless you put it ina pull pull or push push fan configuration. :]
post #3 of 4
Thread Starter 


i was more wondering if This would work. and thanks for the advice against the push push or pull pull configurations. haha.
post #4 of 4
It will work, it will dump the same amount of heat into the case as a typical open fan air cooler, but it will be pulling more away from the GPU faster.

Case temps might rise 1-2C at the worst, gpu temps will drop significantly thanks to the CLC.

For best case scenario, Youll have to think about it alot. I havent had enough coffee to do so.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Water Cooling
Overclock.net › Forums › Cooling › Water Cooling › H90 AIO for GPU in 800D