Okay, so the build is up and running, what else could there be to do?
Well, considering that the fan controller already had a channel die on it... That'll be the first thing that I need replacing. (I can't wait for it to leave my house.... In "manual" mode it ramps up the fans to full speed every 30-45 seconds for no good reason)
I'm also going to be searching for a white UV strip so I don't have to have the purple.
I want a LED RGB strip that I can control the brightness of so that I can add a subtle blue hue to it without detracting from the UV.
I want to get the triple serial bridge for my EK blocks so I can run them in x16 and use the fancy schmancy EVGA sli bridge, and I want my cards to run at the full x16x16 that they are capable of. I didn't realize in the "no slot in between" configuration that they would end up running in x8x8. (Not a big deal, but it supports it might as well use it)
If I can find a UV Blue spray paint that matches, I'd like to paint some rings for my SP120s. I'm also planning on adding controls to the front for the lights, and stuff. I might eventually add a permanent fan controller, but I'll most likely just be using the EK Ascendancy when it releases.
I also plan on getting the EVGA custom cables for my PSU.
Oh, and I might end up adding a 240mm in the bottom where the hotswap cages are, but it all just depends on cash flow and wife's willingness to let me spend more money. I'm on a strict budget of no spending for awhile apparently. "We need to save money for our future blah blah blah."
Good thing I have some stuff I can sell!
I might just have to go back to the normal two slot spacing block that I have already if I add the other radiator though, because if I can't add a 60mm radiator, I won't do it. OCD and all... They have to all match...