Overclock.net › Forums › Case Mods & Cases › Other Hardware Mods › Cables and Sleeving › Depinning black cables out of my CX750M
New Posts  All Forums:Forum Nav:

Depinning black cables out of my CX750M

post #1 of 2
Thread Starter 
Hi Guys, I was wondering about this before i began sleeving my Power Supply. All I see are black cables for my PCIE cables(flat). Is it possible if I depin them all at once, Sleeve them, then put them back in random places.
as you can see they're all black, i was wondering if they would have some voltage limits or grounds, or i can place them anywhere,bcus i dont want to destroy my system if i place them in random spots




THANKS IN ADVANCE smile.gif
smile.gifsmile.gifsmile.gifsmile.gif
post #2 of 2
Quote:
Originally Posted by awesomedude872 View Post

Hi Guys, I was wondering about this before i began sleeving my Power Supply. All I see are black cables for my PCIE cables(flat). Is it possible if I depin them all at once, Sleeve them, then put them back in random places.
as you can see they're all black, i was wondering if they would have some voltage limits or grounds, or i can place them anywhere,bcus i dont want to destroy my system if i place them in random spots




THANKS IN ADVANCE smile.gif
smile.gifsmile.gifsmile.gifsmile.gif

no, you can not just put them any where, that will run the risk of ruining your componenets.

best thing to do is sleeve each cable one by one, or mark down on paper where each cable goes and do it that way

thumb.gif
X7900D
(8 items)
 
  
Reply
X7900D
(8 items)
 
  
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Cables and Sleeving
Overclock.net › Forums › Case Mods & Cases › Other Hardware Mods › Cables and Sleeving › Depinning black cables out of my CX750M