Another reason for which I did the Tanks extensions is that I will use 2 PSU, 2 LEPA G-1600W. However these remain inside the case and are not accessible, so I will use sockets with on-off button.
Initially I wanted to place the PSUs under the Cooling Towers, but the space was little and remained under the RADs, thing I didn't like at all, but now I have much more space, the plug is next to the PSU and not under the RADs.
Here is below the case and positioning
I then made metal extensions covers, that then I'll wrap.
I did 4 panels to size.
I have bent them
Some tests with the Tanks of Bitspower positioning higher and lower
I fasten the cover extensions
and the socket panel
The fan bocks that are inside the 900D were a bit covered by grids, about 25mm per side, thanks to the extension I can overcome this problem, I have "only" widen these grids, that is remake them.
and lower lateral blocks
Test on the case