post #1 of 1
Thread Starter 
Hey guys, it has been for about four months since my second water cooling building was started. I was regret not posting it from the very beginning and now the build is closed to the end. But I think it is not too late to post it to you guys for discuss it, through this platform of which is the highest level of water cooling forums I think

Back to the point, here is the hardware list:

CPU: 4790K
MOTHERBOARD: ASUS M6F
RAM:CORSAIR 4*8G VENGEANCE DDR3 2400MHZ
GPU:ASUS 780TI DCII SLI
SSD:PLEXTOR 128G PX-128M6S
HDD:WD GREEN 2TB*2

Water cooling:
CPU:EK Supremacy Nickel
GPU:EK FC780 GTX Ti DCII - Nickel (Original CSQ)*2 + FC Bridge DUAL Parallel 3-Slot CSQ Plexi
PUMP: EK D5 PWM + XTOP D5 - Plexi (Original CSQ) + D5 Cover Kit (Black) Acetal two sets
RAM: EK Monarch X4 - Nickel CSQ
RESERVOIR: EK-DBAY RES SPIN - Acetal (Original CSQ) + XSPC 270
RADIATORS: ALPHACOOL 480*45MM*2 + 240*45MM + 240*30MM
FAN:CORSAIR SP120*16 + AF140
TUBE: LOCAL BRAND BARROW ACRYLIC TUBE
FITTING: LOCAL BRAND BARROW

I am going to post all the process picture I have got, actually most of them are box open pictures, there are few jobs by hand made and I hope in next build this part could be much more than the present one, here we go






















































Now the only issue I want some valuable opinion is about the right bottom D5 is directly connected to the EK DBAY RES, does it work? If so, I shall modify the loop before the leakage test. Thanks a lot.

Finally tons of thanks for the two build log, they are the "Project DD01" and "900D Maxed Out", which give us most of the inspirations.