Overclock.net › Forums › Cooling › Water Cooling › Question about EK-DCP 2.2 Pump
New Posts  All Forums:Forum Nav:

Question about EK-DCP 2.2 Pump

post #1 of 8
Thread Starter 
In my setup i will have 1 cpu block and 2 gpu blocks with 2x240mm rad and this will be ran in a FULL PARALLEL loop because of my case choice. So will the pump be able pump the water though all this?

Cheers
post #2 of 8
Most likely not. That pump with only 6W is intended for a simple loop with 1 block and 1 rad. I'd go for something with more juice.
post #3 of 8
Thread Starter 
What pump do you think will run this setup?
post #4 of 8
Quote:
Originally Posted by MayhemFighter View Post

What pump do you think will run this setup?

i think eheim pumps will be much powerfull , or going with 2 ddc pumps for a good flow .
post #5 of 8
Thread Starter 
Quote:
Originally Posted by universall1 View Post

i think eheim pumps will be much powerfull , or going with 2 ddc pumps for a good flow .

Sounds good, cheers mate.
post #6 of 8
I'm using DCP 2.2 for CPU block, GPU block, MB block, 240 rad and 360 rad. Run without problem though:D
post #7 of 8
Thread Starter 
Quote:
Originally Posted by deeph View Post

I'm using DCP 2.2 for CPU block, GPU block, MB block, 240 rad and 360 rad. Run without problem though:D

Are the temps good?
post #8 of 8
The temp is good, 34c from AMD FX9590 (still looking any info for stock temp for that cpu).
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Water Cooling
Overclock.net › Forums › Cooling › Water Cooling › Question about EK-DCP 2.2 Pump