Yes a few pictures!
I started late today coffee at 10:00 and start with the build 10:30.
It is now 16:00 hour and i am finished with the things i wanted en needed to do:
- building in the last radiator with the fans;
- drilling holes for the power cables;
The above work only took me 30 minutes.
Then i wanted to put neopreen tape below the glaspanel frame at the back and notice that the countersink screws in the strip dont pull up the led profile enough. ( that means modification) . I removed all the 5 countersink screws one by one. Then i drill tru the tread with a 3mm drill and put a screw in from below. In the countersink hole on top i put a nut.
Making the nuts more flat i used the dremel.
After this job was finished i put on the neopreen tape like i did on the other tree sides. So a patient job again. In my mind i was already putting the Aquero's in.
But ill be back soon enough for som more pictures.
I forgot to show the result from yesterday "workt away cables".
Next job is drilling the last hole in for the last 4 fans at the back.
First removing the fans.
What do i need to do the job. "Ye almost all the tools are there".
First a few small holes then repeat with a bigger drill.
Time for the file.
Clasic mistake to close a few ports before installing the radiator.
Finaly last radiator is in.
And testing again.
Next step is a modification of the mounting the back led profiles. It seems that the screws dont hold the ledprofile enough. So i think i drill the tread out and put a screw in from below and use the countersink hole for putting a nut in.
To smoothen the surface a little i use the dremel.
Last step is to put the neopreen tape on top.
Finished for today.