Originally Posted by ruffhi One of the things that I haven't understood with your bending kits is why you can't secure the 'miter' box to a bench. Every time I watch a vid on your kit I see someone holding the box and cutting it with both the saw and the box moving ... a lot. I was planning on drilling a few holes in mine (when I get it ) and securing it to one of my benches. Then I can use both my hands to concentrate on getting a nice, clean cut and not holding the miter box.
I wanted to add the screws to the inside but it is hard to add a counter bore on the bottom of the half round channel without having sharp edges that will scratch up the tube. I then thought of adding tabs on each end as screw locations but it jacked up the cost a lot--like 2 X. The goal was to keep these as affordable as possible so that was out.
If I make a V2 of the it I will add them. Keep in mind when I did these I had NO idea people would like the kits so much. I was going to sell these to the resellers and some of the modding clubs at cost thinking they would rent or lend them out to their customers / members. We originally made 50 of these, (25 in each size) and I thought that would be it. One run and done.Edited by BoxGods - 2/6/16 at 3:38pm