Originally Posted by CreativeMedia
Interesting, in my first test for this MB I have not managed to do this motherboard Z10PE-D8 WS to work with these non ecc DDR 4 Corsair Dominator Platinum 32GB DDR4 2666MHz CL15 Quad Channel Kit , I get the B1 error on the motherboard display and no boot .
On Asus website i can not find anywhere how to instal other procesor than Intel Xeon E5 V3 family and DDR4 ECC ram : http://www.asus.com/Motherboards/Z10PED8_WS/specifications/
Now have this instaled and work just fine : 2 KIT of Kingston KVR21R15D4K4/64, DDR4, RDIMM, 64GB, 2133 MHz, CL 15, 1.2V, ECC, 128 GB .
My question .... how did you make to work NON ECC DDR4 ram tho this MB ?
The only thing I can think of is the memory was not configured properly, per directions in the manual. You can't just slot them anywhere you want, there is a specific bank you must use and how to pair them. This applies to a number of factors, such as single or duel CPU use. Chances are likely if you see boot issues and you KNOW the memory is tested good, it's your configuration being incorrect. All I did was bought "matched pairs" and installed them per the manual guidelines with no trouble.
Refer to the Asus manual for details, in part below it states:
"When installing DIMMs, always start from slot A1 (CPU1) and E1 (CPU2).• Always install DIMMs with the same CAS latency. For optimum compatibility, it is recommended that you obtain memory modules from the same vendor."
Also, you state it's 2666MHz memory and that is NOT stated as supported in the manual. ONLY up to 2133 MHz is listed as max for DDR4. Right there is a problem that's clearly stated.
Glad things worked out though, best of luck.Edited by HiTekJeff - 2/25/16 at 4:10pm