I Just bought this monitor and wanted to say/ ask few things about it.
*While the 1440p looks amazing, this monitor has seems to have bad QC. There are uneven gaps between actual screen and bezel. Also the gap is bigger on the right side. The lcd sits tight against upper left corner while there is a gap on the right side.
*There is very noticable ,,side-light bleeding** at the edge of the screen, specially when brightness is set above 40 and my room is dark. It seems that there is somekind of glue holding this panel against plastic case but its unevenly spread and just light press will hidde the defect and backlight shining trough it . More or less the same thing extends around the whole panel.
*I noticed few very light scratches on screen coating (not visible during normal use), but now i know its there
*I had piece of plastic stuck between lcd and bottom edge (Dell logo on it)- was pain to took it off without scratching the screen itself. I might have loosened/or damaged this plastic strip a bit, but it holds for now. Not sure how it is attached to rest of the body.
Ok, few questions now;
Is this ,,side bleeding'' normal as I have noticed it on many other monitors as well ?
Should slightly misaligned lcd( relative to bezell) be acceptable?
I am asking because I have tried many new lcd-s lately and all off them have had defects or problems. This one is just most expensive so far...
My monitor is rev A03 June 2016.Edited by Matroxx - 8/23/16 at 1:35am