Overclock.net › Forums › Components › Memory › Please I need assistance with getting this ram to run @ rated speed please (4 x 8GB DDR4 3200 )
New Posts  All Forums:Forum Nav:

Please I need assistance with getting this ram to run @ rated speed please (4 x 8GB DDR4 3200 ) - Page 2

post #11 of 17
Thread Starter 
ive used the XMP option in bios (not switch, assuming they both do the same thing) after reboot and post, i go back into BIOS and for first time ever, i get a hard lock inside the bios! which is why im thinking I need to play with SA voltage settings.. I can boot at 2666 just fine, but after a few minutes i get a system lockup.. 2400 speeds are stable 100%. Im thinking since these modules are double sided, its harder on mem controller, thus needing to adjust SA Volt.... Im gonna try it when i get home from work tomorro.. Hopefully this will cure my issue (fingers crossed) if not, would you think getting another identicle ADATA 4x4GB set to go along with my old set (For 32gb total) would be better.. 8 slots of single sided ram VS 4 slots of double sided ram??? I know the ADATA set can do 3300+ speeds easily
post #12 of 17
Thank you ,unfortunately you don't have pre-sets ,the EZ XMP mention above should help and I would also play with this settings



EDIT; your best bet is to insert one module and set your desire freq./timings -see what timings/voltage they like
Edited by coolhandluke41 - 10/24/15 at 9:23am
    
CPUMotherboardGraphicsRAM
i7 4930K Rampage IV Gene SLI Evga GTX 780 Classy 16Gb TeamX2400c9 
Hard DriveCoolingOSMonitor
Samsung 840 Pro/ Hitachi Deskstar 1TB  H20 (NexXxoS 420+280) w7x64 VG248QE 
KeyboardPowerMouseAudio
Logitech G110 SuperNOVA 1300 G2 G502 Proteus Core Foobar2K/WASAPI >NuForce Icon HDP >Crack with S... 
  hide details  
Reply
    
CPUMotherboardGraphicsRAM
i7 4930K Rampage IV Gene SLI Evga GTX 780 Classy 16Gb TeamX2400c9 
Hard DriveCoolingOSMonitor
Samsung 840 Pro/ Hitachi Deskstar 1TB  H20 (NexXxoS 420+280) w7x64 VG248QE 
KeyboardPowerMouseAudio
Logitech G110 SuperNOVA 1300 G2 G502 Proteus Core Foobar2K/WASAPI >NuForce Icon HDP >Crack with S... 
  hide details  
Reply
post #13 of 17
Thread Starter 
what would you set for "DRAM EVENTUAL VOLTAGE" ??? And thanks for all your help here sir
post #14 of 17
Thread Starter 
do you know of a 32gb 4 stick set of ram that is single sided and uses hynix memory?
post #15 of 17
so is your EZ_XMP switch set to the "ON" position and is the indicator light on?
post #16 of 17
Thread Starter 
Quote:
Originally Posted by flash2021 View Post

so is your EZ_XMP switch set to the "ON" position and is the indicator light on?
i work 24 hr shifts, i wont know till tomorro if the xmp switch will help me here, i doubt it will but i will try. can someone please answer my above question if possible, i would greatly appreciate it
post #17 of 17
Thread Starter 
Update;

Got home and started to hammer down on this ram to figure out all the issues. I tried the XMP switch (does same thing as XMP option in BIOS) i increased my SA Voltage upto 1.35v and even relaxed mem timings to well above factory, and still no boot with this 4x8gb kit.. Did each stick at a time and found 1 stick to be VERY VERY flaky and just didnt want to go above 2666, so there is my issue, 1 bad stick! I setup an RMA with newegg, and will be getting a refund. Old ram is back in and im at nearly 3300MHz with my trusted ADATA 4x4gb set! So all is ok for now.

CAN YOU HELP ME WITH THIS QUESTION!

once newegg applies my refund, i want to try again with a 32gb 4x8gb set. Does anyone know of a single sided 4x8gb mem kit with 3000MHz + speeds? or should i just snag up another exact ADATA 4x4GB set and populate all 8 ram slots and hope for the best? What is my best course of action you think? Thanks a million everyone thumb.gif
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Memory
  • Please I need assistance with getting this ram to run @ rated speed please (4 x 8GB DDR4 3200 )
Overclock.net › Forums › Components › Memory › Please I need assistance with getting this ram to run @ rated speed please (4 x 8GB DDR4 3200 )