Overclock.net › Forums › Case Mods & Cases › Sponsored Builds & Case Mods › [SPONSORED] Custom Parvum R1.0 <<<<< Kinetic Energy >>>>>
New Posts  All Forums:Forum Nav:

[SPONSORED] Custom Parvum R1.0 <<<<< Kinetic Energy >>>>> - Page 22

post #211 of 240
Thread Starter 
Quote:
Originally Posted by Phill360 View Post

Great looking cables. I'm currently building some cables for my rig and I'm using 2.3mm wire and I'm still getting crushed wings.
Just wondering if the case has been built yet because I'd love to see photos of it

Thanks, the cables are not quite finished yet as i won't do the molex and sata ones until i can size up the lengths needed once the case is built . The case is almost done, lots of pic's really soon. thumb.gif
post #212 of 240
Quote:
Originally Posted by Mads1 View Post

The case is almost done, lots of pic's really soon. thumb.gif

Yes, finally the case smile.gif

Look forward thumb.gif
post #213 of 240
Been waiting for this for like 2 years... rolleyes.gif
post #214 of 240
where them cables at biggrin.gif
post #215 of 240
Thread Starter 


A little Update, over the last few evenings i've been sleeving cables for the Silverstone PSU, here are some pic's. thumb.gif










Edited by Mads1 - 3/19/17 at 7:51pm
post #216 of 240
Awesome mate drool.gif
post #217 of 240
Thread Starter 
Quote:
Originally Posted by Goofy Flow View Post

Awesome mate drool.gif

Thanks man thumb.gif

Case pics coming soon........ biggrin.gif
post #218 of 240
Looking good Mads
post #219 of 240
Thread Starter 
Quote:
Originally Posted by paultoke View Post

Looking good Mads

Thanks. thumb.gif Now i just need to get hold of a samsung M.2 for the build and thats all the parts got, its only going to be used for the O/S so i may just get a 250gb one.
Edited by Mads1 - 3/20/17 at 3:54pm
post #220 of 240
Thread Starter 


So ive started to cut the plates and have decided to polish them, not sure this is a good idea cause it has taken me a few hours just to do one so far, and its the smallest of the three. Anyway ive taken a few Pic's in between the sanding stages, although it came out OK, i'm not completly happy with the finish so may go over it again a few times and also may get some 3000 grit just to do a final pass.

I used 600,800,1000,1500 and 2000, plus finished it with Novus fine acrylic scratch remover and acrylic polish.







New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Sponsored Builds & Case Mods
Overclock.net › Forums › Case Mods & Cases › Sponsored Builds & Case Mods › [SPONSORED] Custom Parvum R1.0 <<<<< Kinetic Energy >>>>>