Overclock.net › Forums › Intel › Intel - General › q code b2 after gpu waterblock install
New Posts  All Forums:Forum Nav:

q code b2 after gpu waterblock install

post #1 of 3
Thread Starter 
After a tedious day of installing my custom loop, getting cuts and bruises, my pc won't boot anymore. As far as i know i have no leaks, and the gpu waterblocks are very straightforward to install, even the thermal pads are preinstalled and yes i took off the protective film on the grey thermal pads, the manual states not to attemp removing the protective film on the blue thermal pads so i did not. I used the tim mate that came with the blocks which is non conductive.

Maximus viii hero alpha mobo.
swiftech 980 ti luxury waterblocks.
post #2 of 3
Thread Starter 
I pulled both cards from pcie and it booted fine. Bit it won't boot when either of the cards is installed. Did i killed both of my cards?
post #3 of 3
Thread Starter 
Is it likely to fry a gpu when you power on your system without water in the loop? I powered it then filled it up.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Intel - General
Overclock.net › Forums › Intel › Intel - General › q code b2 after gpu waterblock install