Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Case Mod Work Logs › (Build log) Parvum Project rVe10
New Posts  All Forums:Forum Nav:

(Build log) Parvum Project rVe10 - Page 11

post #101 of 242
Interesting. I'm planning on building in a M1.0 with very similar pump placement and I'm planning on using acrylic too. I might try this thumb.gif Do you think you would get the same result using any soft tubing? I'm wondering if it would look better with clear tubing to match clear acrylic.
Edited by nzphil - 7/20/16 at 3:10pm
post #102 of 242
Thread Starter 
Is that the postman I hear.

post #103 of 242
Awaiting updates biggrin.gif
post #104 of 242
Thread Starter 
Reservoir end caps

post #105 of 242
Thread Starter 
Now the bit we all hate, drilling the hole for the pass-through to mount the res.


Edited by paultoke - 7/22/16 at 6:16am
post #106 of 242
Thread Starter 
Res base installed and connected to the pump.




post #107 of 242
Thread Starter 
Res tube and multi port top on.


post #108 of 242
Looking super clean !!
post #109 of 242
Thread Starter 
Res tube and multi port top o
Quote:
Originally Posted by imersa View Post

Looking super clean !!

Thanks thumb.gif
post #110 of 242
Looking like another nice Build mate. smile.gif
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Case Mod Work Logs
Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Case Mod Work Logs › (Build log) Parvum Project rVe10