post #1 of 1
Thread Starter 
Hey guys, I was ordering some Corsair SF600 individually sleeved cables from cablemod and I already measured the length via a taper measurer and I was just wondering if there was a rule of thumb you guys use for ordering/measuring your cables when you make them?

Like my 8pin CPU was about 160mm if I use the minimum cable length for the cleanest routing almost exactly. I obviously didn't want to order a set for 90$ of cables and find out they are 10mm too short so I was going to +10mm to each length I measured.

https://store.cablemod.com/configurator/#