Overclock.net banner

Bitspower upgrade kit/mod top issues.

184 views 5 replies 2 participants last post by  mtrapuzz 
#1 ·
I bought all the required components to assemble a pump res combo in my define s. I got the mod kit, upgrade kit 250, mod top, and unfortunately a smaller 200mm res as the 250mm was to tall for my case. Everything seemed to be going smoothly until fill up however. I saw a leak around the res so i drained it and although unhappy i took it all apart to investigate and make sure I assembled it correctly. Where the 200mm res meets the mod top adapter, at the o ring, it does not seem to screw down tightly. When you are tightening it and get it almost to the point it should seal properly, the res seems to pop off the threads and come loose. I played with it for a while and decided to try the 250mm res and see if it had the same problem. It seems to screw down just fine and does seem to be watertight. Keep in mind these are all "Z" products so they should be interchangeable with one and other. I know for a fact it is not leaking at the point between the pump top and pump top adapter, where it has the two small orings and the acrylic air stop. I am definitely not new to wcing computers, but am also aware that it is possible i made a mistake. Thanks for any help,
thumb.gif
 
See less See more
1
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top