Originally Posted by Chucklez
I know this is a double post but I really need some help with this. Im afraid if I buy the extender its still going to be too thick and it wont tighten all the way down with then stop fitting right next to it like in my pictures. Searching around I found this EK G1/4 PLUG
now does this tighten down flush inside the G1/4 hole? If so than this would work better than getting the extender but if it doesnt tighten flush then it would have the same issue.
Originally Posted by rx7racer
I have absolutely no idea what you mean, but ok, if you say so, apparently all my EK plugs should be leaking
I just went and checked his link again, g 1/4 stop plug, yeah I have no idea what you are seeing or reading but if you say so, again so be it as it must be since you say it.
I'm not sure where this thread is getting off the rails and I was directing my response towards the OP so not sure why you need to come off with a sarcastic response to me.
The OP was asking if that EK plug quoted just above this sentence would sit flush on his top and allow his fitting to work, and I am saying NO it won't. EK uses recessed holes for some of their ports to allow the plug to sit flush, but since his top is a BP it doesn't have a recessed hole so the EK plug will not work like that.
OP, I will say again you are going to have to make a call or email or ask someone in the BP owner's club to measure the diameter of that extender to see if it will fit. Nothing will be solved by a bunch of confusing posts at this point.