I have a cooler master haf stacker case modded to fit two 480mm radiators in the bottom compartment. I have a monoblock for my r5e motherboard and 5930k. Also have two 980ti's with full cover ek waterblocks and a parallel bridge in between. I also have two ek monarch x4 waterblocks on my ram. I also have a 240mm radiator in the front of the case. I have a swiftec mcp655 pump in an ek reservoir combo and it appears that I do not have enough power in my pump to make it through all of my blocks and radiators. Loop order is pump, front rad, first 480, second 480, then 980ti's, into ram block, then monoblock, then ram block, then back to pump. Am i asking too much from one pump? If i were to add a second pump, where in my loop should I put it and do i need to get another reservoir for it? Or should i do two separate loops?
post #1 of 10
8/9/16 at 8:47pm