So I have these figures all based off of the 120mm cutout plate, because the passthroughs will be drilled in this for the pumps. If I drill outside of this 120mm Plate, the figures should be off by +2 mm (Estimate)
Passthrough/ drilled and set = 10mm showing in Pedestal
Rotary 90 degree full length = 26.6mm
Difference from @Origondoo
[ The 280mm Rad he used was 144mm in Width] Vs EK XE 240mm = 130mm in Width
MM Gained = 14mm from Reference.
This picture shows that the 90degree Rotary is 8mm to Long [ Based on Midpoint of Fitting, from rotary it is 18mm in length]Rotary 90 degree Reference (Click to show)
Here are the Compression Fittings
I used to connect the Soft Tubing in some parts of The Division
Here is the Picture of the Dimensions.
They are 20mm in Diameter which should still work
So here you go. I have 10mm (Passthrough)
26.6mm ( Rotary 90 degree)
2mm Lip of the Compression (3/8 x 1/2" Soft Compression)
for a total = 38.6mm total length from Bottom of 120mm Fan Cutout in pedestal.
So after all is said and done Compared to @Origondoo
Setup, I would have 4mm to play with, then If I make passthroughs outside of the 120mm Fan cutout, I would have 1-2mm of Space to work with on top of the Radiator.