Overclock.net › Forums › Case Mods & Cases › Sponsored Builds & Case Mods › [SPONORED] Projekt Be Massive
New Posts  All Forums:Forum Nav:

[SPONORED] Projekt Be Massive

post #1 of 3
Thread Starter 
Hello Community and best greetings from Germany smile.gif


I work on a Project with support of Aquatuning and Alphacool






I Use the Be Quiet Silent Base 800 Case.
The front door are covered with leather

Hardware:

i7 6700k
4X 8GB Ram
Asus Z170 Sabbertooth mark1 Mainboard
Be Quiet DPP 10
2X R9 390

The The water cooling is sponsored from Aquatuning
The System gets 2 Watercooling circuits in Pastel White and Blue. One for the CPU and the other for 2 Graphic Cards








First Step , I disassembled the case and lacquered it Matt White.

Warning: Spoiler! (Click to show)


The Big radiator was attached at the rear casewall. It was drilled on the fan cover, to be able fix this without screws
Warning: Spoiler! (Click to show)






]After that I remove a lot of the Case. Many small plastic parts excised. The goal was, to bring the 280 radiator as in the front, that I can use on the front flap/Door and this closes cleanly. The holder of the HDD holder, had to get out, to make room for Two pumps.

Warning: Spoiler! (Click to show)








When that is done, I have assembled and mounted to the radiator. Then the assembled 2 pumps with brackets at the bottom. Since I am the day still buy an insulating mat, and to decouple both pumps. I bent galvanized sheet a hard drive cover. This is still covered with White Leather. But I'm going next week in a tannery. Why not order online? I am glad if I can support regional host Creates a little, and know that I so 100% the right leather get (in terms of train / cut resistance, because the edges are not without. Also, it must be quite thin.)


I was thinking to make the cover over the entire length. Unfortunately I do not have to drill good both AGB's cut clean.
Warning: Spoiler! (Click to show)




From motherboard I have removed the cover / Termal Armor. I have the most important sealed with tape and the cover also painted it white. When assembling the black color of the CPU cooler and the Ram tie me did not like. The CPU cooler has now clearcoat on it and Dries. From Ram I have the cooling bars not gotten (probably stuck, so I am considering to buy new for the project.
Warning: Spoiler! (Click to show)




Finally, I once made the first Hardtubes, and the motherboard with 2 graphics cards etc ... provisionally purely hanged.
Warning: Spoiler! (Click to show)





I just hope you understand me. The next update comes at the next weekend. Written course, I can answer. I look forward to your thoughts, questions and criticism smile.gif .



Viele Liebe Grüße/best regard from Munich Germany ,

Felina

Edited by Feliasha - 10/3/16 at 12:31am
post #2 of 3
subbed! :d
post #3 of 3
Subbed!
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Sponsored Builds & Case Mods
Overclock.net › Forums › Case Mods & Cases › Sponsored Builds & Case Mods › [SPONORED] Projekt Be Massive