Overclock.net › Forums › Cooling › Water Cooling › First time to water cooling, asking about Corsair 900D
New Posts  All Forums:Forum Nav:

First time to water cooling, asking about Corsair 900D

post #1 of 2
Thread Starter 
Hello everyone
This is my first time to case mod/water cooling
I got the case, painted it, installed plexi board tray, middle plate, and front cover

I draw a diagram of my tubes, in photo attached, black circles, i want to install pass-thru fittings and 90deg gittings behind the board tray to run soft tubes, i just dicovered that i only have 3 cm space, still did not order the fittings, will they fit? if not, what should I do?
post #2 of 2
Why use 2 reservoir and 2 pumps for a single CPU/GPU? On my 900D I mount my 250 res to dual hard drive rack , pass thru fitting, single D5 pump on the bottom chamber towards the front cover facia with drain port to HW Labs 480 GTS Xflow rad, pass thru fitting on the midplate to GPU input. To top 360 HW Labs SR2 to motherboard block to CPU block and back to reservoir. Also invert your CPU block. I avoid using pass thru fittings on motherboard cover because I have too much wire at the back.
Edited by lovan6 - 12/12/16 at 12:31am
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Water Cooling
Overclock.net › Forums › Cooling › Water Cooling › First time to water cooling, asking about Corsair 900D