Overclock.net banner

lian li PC-O10

11K views 80 replies 16 participants last post by  paultoke 
#1 ·
Welcome to my build log

This build is not based round any particular theme just the addition of a vertical mounted graphics card.

Those of you that have followed me in the past know my preferred cases are Parvum.
Thought It was time for me to move on and try something new.
As i recently bought a Phanteks glacier g1080cpu waterblock i thought it only fitting to use a Phanteks case.
The model I have chosen is a Enthoo Evolv ATX Glass.

UPDATE

Motherboard will not fit without cutting the case around so it will no longer be used
sadsmiley.gif




Now using lian li PC-O10



MAIN COMPONENTS

CASE: lian li PC-O10
CPU: Intel Core i7 6800K Broadwell
MB: Asus Rampage V Edition 10
RAM: Corsair Dominator Platinum
PSU: lian li 750watt sfx Platinum
VGA: GTX 1080 FE
HDD: Samsung
CABLES: Undecided
Lighting: Undecided
Fans: Corsair ML120


WATERCOOLING COMPONENTS


CPU Block: EK-FB ASUS R5-E10 Monoblock RGB Edition
VGA Bock: Phanteks glacier g1080cpu block
Backplate: EK
RES: EK-RES X3
RADS: Magicool G2 slim
PUMP: EK-DDC PWM
FITTINGS: EK
TUBING: Bitspower acrylic
COOLANT: Mayhems
 
See less See more
3
#7 ·
#15 ·
Subbed!
 
#19 ·
Sorry about the picture quality but I just snapped it with my phone.

Did a test boot last night and noticed that the pinouts on the Phanteks are different to the EK and Asus.
Motherboard AURA Lighting Control was set to red, then I connected the Phanteks splitter cable to the motherboard connector.
The GPU waterblock and EK CPU waterblock were then plugged into the splitter cable.
Result was as in the picture, EK turns from red to blue but the Phanteks stay red.
I then plugged the EK straight into the motherboard header and it turns red again.
I suspect the pinouts on the Phanteks splitter are configured for their case lighting strips, should be an easy mod to put right.

 
#20 ·
How to connect the EK RGB connector to a Phantek splitter

Just remove the cables from the EK connector and put them back as shown in the picture.



Its not the correct connector but they will go together.
You can always re pin the cables and use the correct Phantek connector but it works.



All led's are now in sync.

 
#25 ·
Looks like a case change
The motherboard I wanted to use will not fit the case as the plate on the bottom of the motherboard and the angled cable slots cause an issue on the Enthoo Evolv

Motherboard comes out as far as the grey line, if the back panel where the cable holes are was flat that wouldn't be an issue.
In order to make it fit I would have to cut out that bit of the panel and I'm taking to that idea.

Next option is to use a Lian li PC-O10, I only came across this the other day and was put off buy the sfx power supply only option. Being as I had already purchased a full size atx power supply.

I started to do some investigating and discovered to my surprise they are starting to make some really nice sfx power supplies so I bit the bullet and bought it.

 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top