post #1 of 1
Thread Starter 
Hi guys,

I've ordered a Sapphire RX 480 Nitro+ OC 8GB, so figured i'd try my hand at volt modding my old Inno3D Geforce GT 630 4GB DDR3,
I am somewhat clueless about reading this PCB and the process of volt modding. This is my first attempt, so I don't mind the outcome.

The chip is the the non-Kepler based one, I believe it is based on Fermi, it runs ok on low settings with some modern titles, but at most 30 fps average.
I'd like to overclock it as much as possible out of interest, but the locked voltage is a problem.

Mem 533 | 566OC
Clock 810 | 866OC

Can you guys with the experience help me?

Here are the specs: