Still haven't finished my 24 pin cable, taking it slow and hoping to get it right. I was also slowed down because I had to get my Dad's modding tools back to him for a build he is doing.
I have been getting my own tools and and am awaiting the last piece of equipment; a Thermaltake Dr. Power II which should be here on Wednesday!
I was labeling my wires to make it easier to wire the connectors up and found out something interesting, my Seasonic Snow Silent 750W PSU doesn't use pin 20, it splices the 24 pin's #2, #3 and #21 pin spaces, but #20 isn't used. And I can see on the factory cable that they don't even have a wire in that pin location.
I am sleeving cables, and I want my 24 Pin to PSU to run down the inside of my case, if I leave that wire off, it won't look right. Does anyone have a solution, can I just put the wire in there and not worry about it making continuity with the PSU and Mobo?
I was trying to figure this out, if I don't want it to have continuity, I could cut the #16 AWG wire take a 1 inch piece of the wire jacket and superglue it on the the two leaving a gap in the wires, then sleeving it so you can't tell there is a break.
Any help would be appreciated.
Edited by SirLoin - 4/10/17 at 3:52pm