Overclock.net banner

NO BOOT if i put RAM into DUAL CHANNEL - CPU/CHASS FAN STOPS AND RUNS CONTINUOUSLY

170 views 2 replies 2 participants last post by  lampje 
#1 ·
hi,
i had old pc with no use, thought i should use it so i sent it to my office,
its mobo: Gigabyte b75d3h-m 1.2v
Corsair vengeance ddr3 2x4gb
CPU: i5 2310

the problem is if i put Ram into dual mode, cpu+cabinet fan stops then start then doing same again and again,
but if i put ram into single channel then all works fine,
i tried to put single ram on all slot, all slots are working,

this motherboard have 4x8pin of 12v but i only installed 4pin connector instead of 8,
actually office computer have normal power supply, i thought this problem is due to 12v 8pin connector, then i tried to run pc with gaming PSU(home pc)
no changes..

so where can be the problem ? help!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top