Originally Posted by sirokket16
dervman, what are your temps for your bridges after applying those fans? Also, what are your cpu temps and your voltages for all?
I don't know what the exact bridge temperatures were because I didn't have any software that could read those values.
However, I did attach a probe to the southbridge and it read about 55 degrees. Using that as a baseline, I would say the northbridge was around 40 degrees. It was hot to the touch, but not uncomfortably so, which the southbridge was. Adding the fan to the northbridge made a big difference, before that I couldn't touch the heatsink for more than about 5 seconds. It's worth noting that the southbridge fan didn't make much difference.
Normally I ran at 333x9. VCPU was 1.2v (it read 1.18v in windows). VNB needed 1.25v to survive orthos for more than an hour. Everything else was auto/lowest.
The highest I ran was 389x9, which was the max I could get could get from the chip. VCPU was 1.6v, VNB needed 1.3v.
I found the VNB needed 1.4v to get much over 400FSB and the VSB also needed boosting a notch. Then it just seemed to hit a wall at 490FSB where adding more voltage anywhere made things hotter but didn't let it run any faster.