Originally Posted by CrazyJoe
Thanks ira-k ... that'd be great !
I'm still in the process of building my rad enclosure, so it may be a bit.
Can you recommend a good in-line temp sensor I could integrate into my loop ? Before and after the rads the best place for that then ?
Yeah I'll link to the one's I used and I will link to the compu-nurses I hooked them up to...The probes come with a 2 pin connector I just cut off the flat probe off the compu-nurse and added a 3-pin male molex with just 2 wires on it of course...
..None of this stuff is real accurate but it will give you a pretty good idea of temp's...
I put one right before the rad and the other one I put closer to my case...I wanted to get it closer to the CPU...I used some 1/2" T's and reamed them out a little then seal-threaded these probes in them with some clear silicone...I put the tips right down in the flow a little to try and get accurate temp's...Then I put some heat-shrink on it and shrunk it....They have held up fine so far....
I will leave you a pic link it is to the left of my pressure gauge in the...That is an old pic...
I made some little face plates for them and cut them into the front of my case...
You might want to look around for better prices on these....
Alphacool TEMP Thermosensor G1/4" fitting Products Model: 17513  : Performance-PCs.com,
Digital Thermometer with Blue LED Back Light [TTR-M4-B]