Overclock.net › Forums › AMD › AMD Motherboards › Asus A7V8X-LA /w Sempron 3300+?
New Posts  All Forums:Forum Nav:

Asus A7V8X-LA /w Sempron 3300+?

post #1 of 3
Thread Starter 
Hello, I have the following system:
Compaq SR1300NX:
CPU AMD Sempron 3000+ running at 2.0 GHz (12 x 167)
CPU Alias: Barton
CPU Stepping A2
Instruction Set X86, MMX, 3DNow!, SEE
L1 Code Cache: 64 KB
L1 Data Cache: 64 LB
L2 Cache: 512 KB (On-Die, Full Speed)
Package Type: 453 Pin PGA (Socket-A)
Number of Transistors: 54.3 million
Die Size: 101 mm2
HS&F Custom installed Cooler Master. Dremeled hole for placement of rheostat and knob to adjust R.P.M. Arctic Silver 5 was used for the impeccable heat transfer.
Memory Corsair (2) 1 GB PC3200 (200 MHz) DDR SDRAM with Thermal take heat spreaders.
Timings: At 200 MHz 3.0-3-3-8 (CL-R
CD-RP-RAS)
Voltage: SSTL 2.5 V
Chipset North Bridge: VT8378A UniChrome KM400A
South Bridge: VT8237
Supported FSB Speeds: 200 MHz, 266 MHz, 333 MHZ, and 400 MHZ Core Voltage: 2.5 V
Memory Bank Interleave: 4-way
Memory Timings: CAS Latency :3T
Command Rate: 2T
Audio Audio Controller: VIA 8233/8235/8237/8251
Codec: Realtek ALC658
BIOS Award
Award BIOS Type: Phoenix BIOS v6.00PG
Hard Drive Maxor 6L100M0 DiamondMax 10
Size: 100 GB
Speed 7200 R.P.M. SATA 1.5 Gbit/s
Buffer: 8 MB (Dual Ported, Read Ahead)
AGP Graphics Diamond ATI Radeon X1650 Pro (AGP) (X1650AGP512SB)
BIOS String: 11x-8C8503BD-001
Chip Type: ATI Radeon Graphics Processor AGP (0x71E6)
Memory Size: 512 MB DDR2 128-bit memory interface
Memory Speed: 800MHz
Core Speed: 600 MHz
Shader Model 3.0
DirectX® 9.0
CrossFireâ„¢ ready
Dual-link DVI output
Video-out
VGA
Maximum Resolution: 2560 x 1600
Rear Fan Thermaltake TT-9025A-2B 90mm Case Fan
Air Flow: 56 CFM
Bearing Type: 2 Ball
Noise Level: 35 dBA
Power Connector: 3 / 4 Pin
RPM: 2850±10% RPM
Power Supply Antec SmartPower 2.0 SP-500 ATX12V 500W Power Supply 115/230 V TUV, UL, CUL, CE, CB, FCC
Series: SmartPower 2.0
Type: ATX12V
Maximum Power: 500W
Fans: 2
Main Connector: 20+4Pin
Dual +12V
PCI-E Connectors: 2 x 6Pin
SLI Support
Modular Cabling Support
Efficiency: 70%(min.) at full and typical loads, 115V/230Vac
Voltage Protection: +5V trip point < +6.2V, +3.3V trip point < +4.1V, +12V trip point <14>80,000 Hours
Connectors:
1 x Main connector (20+4 pin)
1 x 12V (P4)
6 x peripheral
4 x SATA
2 x Floppy
2 x PCI-E
Optical Drives ASUS CRW-4832AX & Sony DVD RW DRU-810A
CD-RW DVD+RW/DVD-RW
CD-R: 48X DVD+R9 Dual Layer: 8X
CD-RW: 32X DVD+R: 16X
Reading Speed: 52X DVD+RW: 8X
DVD-R9 Dual Layer 4X
DVD-R: 16X
DVD-RW: 6X
CD-R: 48X
CD-RW 32X
Reading Speeds:
DVD=ROM: 16X
CD-ROM: 48X
Mouse & Keyboard Microsoft Wireless Laser Mouse 5000
Microsoft Internet Keyboard
Head Set Unknown Logitech Model (Mono) With Mic
Monitor Compaq 7550
Monitor ID CPQ1446
Monitor Type: 17' CRT
Picture Aspect Ratio: 4:3
Maximum Visible Display Area: 32 cm X 24 cm (15.4')
Horizontal Frequency: 30 - 86 kHz
Vertical Frequency 50 - 140 Hz
Maximum Resolution: 1600 X 1200
Gamma: 2.88
DPMS Mode Support: Standby, Suspend, Active-off

-------------------------------------------------------
http://valid.x86-secret.com/show_oc?id=207547
-------------------------------------------------------


I would like to know if I can upgrade the Sempron 3000+ to a 3300+
Any help would be great. Thanks!
Sethwm2@gmail.com
post #2 of 3
Wow talk about too much un needed info.

Next time just say you have a Sempron 3000 and a A7V8X-LA and want to put in a Sempron 3300

Answer:

Yes it should have no problems running a Sempron 3300, however why would you spend the money on a 3300 it's only a slight performance boost. Your money would be better spent on say an Athlon Socket 939 CPU and motherboard.
post #3 of 3
Thread Starter 
Well since this is a Compaq... I was wondering if the BIOS was locked from using any other CPU than Stock... I attempted to install a 2700+ Athlon XP 2.15 GHz and it did not boot... So Proprietary?
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: AMD Motherboards
Overclock.net › Forums › AMD › AMD Motherboards › Asus A7V8X-LA /w Sempron 3300+?