hey friends, for those of you that remember my fault mobo, that didnt saved the bios changes, i got the latest GA-P35-DS3 rev 2.1, Bios F12 overclocks like HELL!!!!
Question, My system is Low temps and 10000% stable in those:
Q6600 G0 running at 333*9=3.0ghz
Memory Kingston XyperX 1066 Runing at 800 / Auto 126.96.36.199
factory says 188.8.131.52
Question Because i Use all 4 Slots , How can i have a STABLE system ruuning all 4GBytes in 1066??? by changing the 2:4 to 3:2 and +2v to ddr2 doesnt give stable system!
best seting for 4gb XyperX kingstons at 1066 anyone??? tnx
If I were you I knock my memory down to 1:1 and tighten timings, run memtestx86 a dozen passes and if it's good start bumping it up from there. You can't be stable if you have bad memory. I had increasing Vddr .1V over rated got rid of errors. Once you run your memory as high as it will go without error then you can up CPU and Vcore to suit. It may be backwards to some people but I figure that way I can tell if it's my cpu unstable if memory is already setup good.
Also maybe 4GB won't clock as well as 2GB somtimes. If u are running 4 chips you could try 2. Aslo tom's hardware had a good memory shakedown a few months ago and kingston hyperx was in there. I bet you could figure a lot out about you memory there. Good luck!
Edited by claytona - 6/2/08 at 3:30pm