Originally Posted by thlnk3r
Jamy, just by judging by that screenshot you may have to adjust a few things. Try getting your HT (hypertransport) speed below 1000mhz. Right now your at 1114mhz which may cause some problems if you keep raising your HTT (reference clock). Change the HT multiplier from 4x to 3x.
Relax your CAS (memory sub-timing) from 2.5 to 3 and see if that helps. I would also drop your memory to a lower divider. Try and get that memory below the factory 200Mhz. I'd advice tweaking your memory later on after you've gotten your processor stable.
Try those things above and see if it helps
think3r.., i hav done as u told. But y the HTT should b kept < 1000 Mhz. wat mi8 b the techinal reason 4 that..??? i wish if i cud noe that
by the way i will juz add here the deatils f ma DRAM config :-
memclock index value : (333Mhz) [Shud i keep it in 333 itself..?? or reduce it ?? The minimum is 200mhz]
RAS : 8T
RAS to CAS : 3T
Row Precharge time : 3T
Row cycle time :11T [I shud change the timing here??
Row Refresh Cycle Time : 14T [I shud change the timing here??
Read to Write Time : 5T
Write Recovery time : 3T
1T/2T mem... : 1T [default was 2T. Shud i change it 2 Default...??
Now here goes ma "Jumperfree config" :-
CPU Freq : 278.0
PCI Express Clk : 100Mhz [No idea watz this bout
. Plz help ]
DDR Voltage : 2.9V
CPU Multiplier : x9
CPU Voltage : 1.425 [ Default was 1.420]
PCI Clk Synch Mode : 33.33Mhz [Am i right here??
Hav Reduced HTT below 1000Mhz. Now itz 835.5 [278x3=835]
So Think3r,,,, NOW WHAT????????????????
Sorry 4 killing ur Time.
And Thankz Again