Alrite, I got some stuff done today
I made the holes wide enough for the can to fit threw..
(the cans will be straight, I just angled them so they wouldn't fall threw)
Grinded off one end of the can.. (dremel bit in the truck, which isn't here...)
I realized the insides of the cans actually don't look that bad... (see below picture)
When I put the can in the first hole, I realized why can't I just cut the both ends off nice and the put them in the holes permanently? I could build up the bondo on the outside and keep the inside the metal.. There would be no sanding and I think the metal would look better (if it doesn't look good I could just sand and paint the metal)... What do ya guys think?