Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Should hole saw work fine?
New Posts  All Forums:Forum Nav:

Should hole saw work fine?

post #1 of 3
Thread Starter 
In a min im going to go pick up my 780i for the second time.......

Im planning on doing a cable management mod with my case so im stopping at lowes after frys.

I dont need the holes to be more that 1.5 inches wide so would a 1.5in bi metal hole saw work just fine? I also saw some 1.5inch rubber gromets there that look like they will work fine. Also what glue should i use to glue the grommets to the metal?
post #2 of 3
Thread Starter 
I Have To Leave Right Now :0
post #3 of 3
a hole saw is best to drill holes in your case. i generally use super glue for work around the case.
    
CPUMotherboardGraphicsRAM
E8400 @ 4.1 GHz ASUS Maximus Formula Undecided Corsair Dominator 4GB @ 910 
Hard DriveOSPowerCase
Barracuda 250GBx2 Raid 0 XP Hiper 880W Thermaltake ArmorPlus 
  hide details  
Reply
    
CPUMotherboardGraphicsRAM
E8400 @ 4.1 GHz ASUS Maximus Formula Undecided Corsair Dominator 4GB @ 910 
Hard DriveOSPowerCase
Barracuda 250GBx2 Raid 0 XP Hiper 880W Thermaltake ArmorPlus 
  hide details  
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Case Mods
Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Should hole saw work fine?