Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Possible Rocketfish mod (floor flange, nipples and caps)
New Posts  All Forums:Forum Nav:

Possible Rocketfish mod (floor flange, nipples and caps)

post #1 of 3
Thread Starter 
I want to raise the case off the floor about 2-4" and put a fan on the bottom. What have you been using for feet. I just bought some 1/2" floor flange, 2" nipples, and 1/2" caps but I'm worried it might look to "industrial".

I'd bolt the flange to the underside of the case and use the rounded caps for feet.. I'm sure it would help with air flow under the case.

Or else I could use those rubberized leg caps for furniture.
post #2 of 3
I'm thinking of raising my RF a few inches too, but I may install wheels instead. Wheels will look nice, make it easy to move the case around, and provide plenty of room for a fan.
i7
(14 items)
 
  
CPUMotherboardGraphicsRAM
i7 920 D0 Foxconn Bloodrage EVGA 9800GX2 G.SKILL 6GB DDR3 
Hard DriveCoolingOSMonitor
WD 640GB MCR 220 + Feser Quad 7  Dell 22" 
PowerCase
Corsair 650TX Test bench 
  hide details  
Reply
i7
(14 items)
 
  
CPUMotherboardGraphicsRAM
i7 920 D0 Foxconn Bloodrage EVGA 9800GX2 G.SKILL 6GB DDR3 
Hard DriveCoolingOSMonitor
WD 640GB MCR 220 + Feser Quad 7  Dell 22" 
PowerCase
Corsair 650TX Test bench 
  hide details  
Reply
post #3 of 3
Thread Starter 
Castor wheels? Hmmm...that's a better idea.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Case Mods
Overclock.net › Forums › Case Mods & Cases › Builds & Case Mods › Case Mods › Possible Rocketfish mod (floor flange, nipples and caps)