I've been unable to achieve any kind of OC with my system which is quite frustrating at this point. I've been using OC guides for my MB that I've found on some searchs with little or no success. Everything that I''ve read about my board and processer say that they are very overclockable. Could the memory be an issue, or PS? As stated previously, at this point a minor increase would be encouraging . I'm not anywhere near ready to give up on this. I've been unable to find either on the manufactures web site or in other searchs the stock specs on my memory
PNY 2048MB Dual Channel PC6400 DDR2 Memory 2x 1024MB), the closest #'s I've found is the retailers site where I purchased them; 5-5-5 the tRAS is not given nor the stock voltage. I've been unable to see these numbers on the modules themselves because they have manufactures heat sinks on them. I've set my timings manually to 5-5-5-18 and my voltage between 1.8-2.2 volts. I don't know how much of a difference this makes with the failures I'm having. I've tried increasing my FSB speed to 1333 from 1066, and from 1066 to as little as 1100. I bumped my vcore voltage up to 1.4 to see if that would help. I think I'm close to having an increase, but as of yet. Anyone have any ideas as to where my hang ups might be, or if you need any other information. Thanks again.