Originally Posted by FearMeansControl
good luck finding a really high end board in uATX
Definitely post some pics when this is done though, if you've fit a water loop in there... then that's just downright impressive
oh, the water loop is in. i tested it out on a lapped 3600+ with a cheap biostar mobo. load temps at 2.8ghz didnt get above about 35c. due to fsb limitations on that mobo i couldnt get it OCed any higher. here is whats in the case along with pictures...
case -Lian Li V350
block - Dtec Fuzion
res - swiftech micro res
rad - BlackICE2 240mm
pump - Swiftech MCP655
The setup has been cleaned up quite a bit since this picture, the pump was mounted to the case cover, extra power supply cables were de-soldered and excessive length was trimmed from everything else. and yes it does fit!
and here is the side of the case where the res what fitted for viewing pleasure!
and i did find a ASUS uATX mobo thats rated at 140w so....