Ok guys next update!
I HAVE MY FIRST SPONSOR FOR THIS PROJECT!!!
and they are.....
Joan from crucial is sending me a 2gb kit of their ballistix ddr2 ram
and on with the work.
I started working again on the angled pieces for the hdd module and got them all polished up
I then came up with a way of getting all the holes drilled in the right place
First hole on the hdd module drilled
Tapping both the acrylic and the module for an m4 socket head bolt
first angle done
jumping forward all 4 done
then i just thought i would randomly stack up the pump/res, hdd and dvd modules as they were at the time!
I then got the angle pieces for the dvd drive module cut out and polished
then i thought i would just take the two modules that i had done the angles for inside and weigh them
these two weighed nearly 3 lb together and thats without the ends and the hardware so this is going to be one heavy case!
then i took the hdd cage out of my current case for modification
I then took my bench grinder to these tabs etc that arent needed
and to some more bits on the bottom that arent needed and just get in the way
And this is what i was left with.
then i took my dvd drive and marked out the front of the module for cutting
and thats it for today!
Hope you enjoyed it.
I have the same amount of time tomorrow to mod so be sure to check in and see what i have accomplished!