Yeah, the way it is set up with the Mobo fairly low. This way the GPUs' are easier to cool and I can set RADs wherever I want them. I'm thinking a 4x140mm setup to use the stock 140s' but I'm going to be shaving about a half inch off the inside edges to make a single grill. So one case is going to lose a whole inch off it. And two of them will completely lose the I/O panels and get the grill extended up front so only the middle one gets the I/O panel but the Power and Resets will probably be Red Vandal switches as well as a BIOS reset switch. Not sure how(or if) I'm going to do that though.
I think I've got to re-skin the doors too cause with the size of it I'm not going to need the louvres for venting.
Oh I went back and took another look at the ABS? I don't like how you're stuck with 2 5.25s' and a 3.5 on both sides. That's whack. It's great that you can HAVE 6 drives but it's a weird orientation. If it had a spot for a 2nd MoBo and Power Supply combination it would be a great 2 in one system configuration for a work cubicle, but the way it's set up now they want too much for it.
Originally Posted by wermad
You looking to setup the mobo horizontal? Mountain Mods does offer a Horizon option on the u2ufo/ascension where the mobo tray can be setup horizontal
, are u planning something like this?
I didnt go w/ this option as it was going to tack on another $40usd and the back plate was going to throw off my wc setup. just did the the 10pci mobo as it sits a little higher and for future proofing