Originally Posted by XtremeCuztoms
k, well installed UD3P tonight, updated everything, installed all needed drivers, installed Razer KB and Mouse drivers, Printer drivers. but every time i reboot or restart i will not load past load screen with everything (USB) plugged in the back. the only way it boots is with PS/2 KB plugged in.
in the bios i have set for legacy usb mouse and KB. so i need to restart but hate to since i will have to unplug everything and only us a PS/2 KB. any thoughts or suggestions?
When you load Optimal Defaults the USB devices will not work until you go into the BIOS ( Int Peripherals) and enable all of them. Always perform CMOS reset and Load Op Def in this way
Shut down--unplug-- hold start button in for 10 sec--short the CMOS pins in lower right corner of mobo for 1 minute using a flat screwdriver--plug back in-start--
Load Optimum Defaults--Set PCIe to 100--Set ram timings-- setDRAM voltage--go to Integrated Peripherals-enable all USB settings(they are at the bottom of the page)--go to Advanced BIOS Features,init display-select PEG
Also the boot order will need attention