Okay so this had a 1/3hp 230vac motor on here. Sadly this meant that, to get a 110vac motor and keep the same fan grill and fan blades, I had to find specific mounting holes. A big thank you goes out to Copeland for there wonderful sourcing department, who actually found me the matching 110vac motor to their 230vac motor in bolt size and everything... and then showed me where to buy it at the cheapest price FROM A COMPETITOR. I must say; that is not necessarily "customer service" but it is certainly "customer assistance" at it's maximum.
A pondering of new bolts later, finding this wasn't mounted on 8-32's but 10'-24's, a redrilling of a few holes in the mounting bracket, and kabam the condenser was ready. So what happens when you finally turn on a 1/3hp motor attached to a very large 16" fan that still hasn't actually been bolted down? Oh nothing; except the entire cascade started rolling in the opposite direction.
Did I mention it's a tight fit?
Compressor 1 and 2 aren't going to have "cooling" issues.