Originally Posted by tonyptony
but can a Mugen 2 be set up with a push-pull arrangement in the Scout? I want to keep both the rear and top fans in place for this setup.
My Kama Angle Rev.B is 123x123x160mm
without the fan/s.
The Mugen 2 is 130x110x158
without the fan's.
Link to my rig here so you can see:- http://www.overclock.net/computer-ca...l#post10455535
If you mount the Mugen 2 the widest side up, you won't make clearance for the top fan, but either way you'll clear for the rear exhaust.
I have enough space for a Pull Fan on my Rear-side and about a 20mm gap 'til the Rear Fan, and about 21-22mm from the top of my cooler to the Top Fan.
Depending on what way you go for Push/Pull, as long as you mount the thinnest side where you want the fans to be, you'll be clear with maybe 10mm or so of space from your top pull to the top fan, and about 38mm to the rear fan with the rear pull on your Mugen.
I did hear however, that having a Push/Push configuration is slightly cooler (by 1 or 2c), I.E:- _l <-Both fans that side of the Mugen/Ninja 3 Etc.
Also if you want a 4-way Push/Pull, make sure you mount the 110mm side facing the top exhaust, that's the only way you'll get both pull fans on it, that'll leave you with about 10mm clearance for the top and about 13mm on the rear.Edited by EvoBeardy - 8/28/10 at 8:41am